Part Number Hot Search : 
KBPC806S R1632 BAV21 SMAJ11A GP30B 10030 HCT05 MR2402R
Product Description
Full Text Search
 

To Download MSK4370 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 ISO 9001 CERTIFIED BY DSCC
M.S.KENNEDY CORP.
4707 Dey Road Liverpool, N.Y. 13088
10 AMP, 500V, 3 PHASE IGBT BRUSHLESS MOTOR CONTROLLER
4370
(315) 701-6751
FEATURES:
500 Volt Motor Supply Voltage 10 Amp Output Switch Capability 100% Duty Cycle High Side Conduction Capable Shoot-Through/Cross Conduction Protection Hall Sensing and Commutation Circuitry on Board "Real" Four Quadrant Torque Control Capability Good Accuracy Around the Null Torque Point Isolated Package Design for High Voltage Isolation Plus Good Thermal Transfer 60/ 120 Phasing Selectable
MIL-PRF-38534 QUALIFIED
DESCRIPTION:
The MSK 4370 is a complete 3 Phase IGBT Bridge Brushless Motor Control System in an electrically isolated hermetic package. The hybrid is capable of 10 amps of output current and 500 volts of DC bus voltage. It has the normal features for protecting the bridge. Included is all the bridge drive circuitry, hall sensing circuitry, commutation circuitry and all the current sensing and analog circuitry necessary for closed loop current mode (torque) control. When PWM'ing, the transistors are modulated in locked anti-phase mode for the tightest control and the most bandwidth. Provisions for applying different compensation schemes are included. The MSK 4370 has good thermal conductivity of the IGBT's due to isolated substrate/package design that allows direct heat sinking of the hybrid without insulators. The anti-parallel commutation diodes are ultrafast recovery types for high efficiency/low switching losses.
EQUIVALENT SCHEMATIC
TYPICAL APPLICATIONS
3 Phase Brushless DC Motor Control Servo Control Fin Actuator Control Gimbal Control AZ-EL Control
PIN-OUT INFORMATION
+Vcc -Vcc Hall Input A Hall Input B Hall Input C Compensation 1 SIG GND Brake Disable
1
Power+ CO BO AO Power Return (GND) Current Command + Current Command Current Monitor Compensation 2 60/120
PRELIMINARY Rev. A 6/00
ABSOLUTE MAXIMUM RATINGS

ELECTRICAL SPECIFICATIONS
Parameter POWER SUPPLY CURRENT +Vcc -Vcc PWM Free Running Frequency CONTROL Transconductance Current Monitor Output Offset HALL INPUTS Low Level Input Voltage High Level Input Voltage ERROR AMP Input Voltage Range Slew Rate Output Voltage Swing Gain Bandwidth Product Large Signal Voltage Gain OUTPUT Rise Time Fall Time Breakdown Voltage Leakage Current Voltage Drop Across Bridge Diode Forward Voltage trr Dead Time @ 50A @ 500V @ 10 Amps @ 10 Amps IF=10 Amps, di/dt=100A/S 8 Amps Output 8 Amps Output @ 0 Volts Command No Clock Sync +Vcc=+15V -Vcc=-15V Test Conditions
All Ratings: Tc=+25C Unless Otherwise Specified MSK 4370 Min. TBD TBD 20 1.9 0.9 3.0 11 6.5 12 175 500 Typ. TBD TBD 22 2 1 5.0 12 8 13 6.5 275 2 2 2 Max. TBD TBD 24 2.1 1.1 0.8 50 5 1.5 60 Units
2
PRELIMINARY Rev. A 6/00




Continuous Output Current Peak Output Current

-55C to +125C +150C










V+ VIN +Vcc -Vcc IOUT IPK
High Voltage Supply Current Command Input
500V 13.5V +18V -18V 10A 20A
JC Thermal Resistance TST Storage Temperature Range TLD Lead Temperature Range (10 Seconds) TC Case Operating Temperature TJ Junction Temperature
1.5C/W -65C to +150C +300C
mA mA KHz V/amp V/amp mAmp Volts Volts Volts V/Sec Volts MHz V/mV Sec Sec Volts Amps Volts Volts nSec Sec
MECHANICAL SPECIFICATIONS
ESD Triangle Indicates Pin 1. NOTE: ALL DIMENSIONS ARE 0.010 INCHES UNLESS OTHERWISE LABELED.
ORDERING INFORMATION
MSK4370 H U
LEAD CONFIGURATIONS S= STRAIGHT; U= BENT UP; D= BENT DOWN SCREENING BLANK= INDUSTRIAL; H= MIL-PRF-38534 GENERAL PART NUMBER The above example is a Military grade hybrid with leads bent up. 4707 Dey Road, Liverpool, New York 13088 Phone (315) 701-6751 FAX (315) 701-6752 www.mskennedy.com
The information contained herein is believed to be accurate at the time of printing. MSK reserves the right to make changes to its products or specifications without notice, however, and assumes no liability for the use of its products.
M.S. Kennedy Corp.
3
PRELIMINARY Rev. A 6/00


▲Up To Search▲   

 
Price & Availability of MSK4370

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X